2005 > 2008
1. INSERT key into ignition, but leave in the OFF position.
2. With ignition OFF connect
pins 1 and 4 of the OBD connector
together using a suitable jumper pin.
3. Within 10 seconds of
connecting the jumper switch PRESS
the HAZARD button 6 times.
4. The doors will LOCK and UNLOCK and HAZARDS should flash to indicate programming mode.
5. Immediately PRESS and release the ANY button
on the first remote transmitter.
6. Within 10 seconds PRESS the ANY button of the same remote TWICE.
7. The doors will LOCK and UNLOCK.
8. Repeat steps 5 to 7 for all additional remote
transmitters.
9. Check all remote transmitters for correct operation.
10. Remove the jumper
connection.
NOTE :
ALL remote transmitters must be programmed within 1 minute of entering the
programming mode.
NOTE :
Programming mode will end when 4 transmitters are programmed, Jumper is
disconnected or Ignition is switched ON.
NOTE :
ALL remote transmitters programmed, will be erased once programming mode has
been enabled.