FORD REMOTE – THIS PROCEDURE RESETS ALL REMOTES FOR THE VEHICLE. ALL FUNCTIONING REMOTES WILL HAVE TO BE REPROGRAMMED DURING THE PROCEDURE

Make sure that you do not press the brake pedal at any time during or before the procedure.

Procedure A:

1.    CLOSE all doors, then OPEN drivers door and PRESS the UNLOCK button on drivers door while it is OPEN.

2.    INSERT key into ignition.

3.    SWITCH ignition from OFF to ON 8 times within 8 seconds, with the 8th time ending in ON.

4.    Door locks will CYCLE to confirm programming mode. (If the door locks do not cycle, then it was done incorrectly. You must start over by removing key and beginning from step 1)

NOTE : Off is the position where you can remove your key, ON is the position before starting your car.

5.    WITHIN 10 seconds PRESS any button on the first keyless remote to be programmed. Door locks will CYCLE to confirm programming.

6.    REPEAT step 5 for any additional remotes. If you only have one remote then skip to step 7.

7.    Turn ignition to OFF. Locks will again cycle to indicate end of programming mode.

NOTE : If this does not work try the procedure with the door closed.

Procedure B:

1.    FASTEN seatbelt and CLOSE all doors.

2.    SWITCH the ignition from OFF to ON 4 times within 3 seconds.

3.    Turn the ignition OFF. The system will CHIME to confirm programming mode.

4.    WITHIN 10 seconds, press and hold any button on first keyless remote. The system will chime once to confirm programming.

5.    REPEAT step 4 for all additional remotes.

6.     SWITCH ignition to ON to exit programming mode.