NOTE : A working remote control is required to perform this procedure..

1.    PRESS the LOCK button 5 times at 2 second intervals to resynchronize transmitter.

2.    SWITCH ignition to RUN position.

3.    Ignition will CHIME, PRESS UNLOCK to stop CHIMES.

4.    Using any original working transmitter, PRESS the UNLOCK button for 4 to 10 seconds.

5.    Within the specified 4 to 10 seconds, continue pressing the UNLOCK button and PRESS the PANIC button for 1 second and RELEASE both buttons.

6.    A chime will sound to indicate that the transmitter programming mode has been entered.

7.    WAIT for 3 seconds for CHIME to sound.

8.    Now with NEW remote PRESS LOCK and UNLOCK buttons simultaneously for 1 second and RELEASE.

9.    PRESS and RELEASE any button on the same remote and a CHIME will sound after successfully programming and locks may cycle.

NOTE: A CHIME WILL NOT SOUND ON STEP # 6 FOR THE FIRST TRANSMITTER PROGRAMMED, BUT WILL SOUND UPON PROGRAMMING THE SECOND TRANSMITTER.

NOTE : YOU MUST REPROGRAM ALL ORIGINAL REMOTES

10. Repeat steps 8 through 9 to program additional transmitters.

11. SWITCH ignition to OFF position.

12. Remote programming mode will stop after 60 seconds .

NOTE : Check all remotes for functionality.