ALL
ADDING
NEW SIGMA REMOTE TRANSMITTERS TO SYSTEM
IMPORTANT
NOTICE:
When teaching one or more radio
transmitters into the security system ALL
previous radio transmitters will be erased from the security system.
You must teach ALL the radio transmitters during the Teaching New Radio
Transmitters to the Security System process.
When using the keypad, each time a button
is pressed the LED on the keypad
will FLASH ONCE as confirmation.
NOTE : DO NOT the next button until the keypad
has flashed once to confirm button has been pressed.
NOTE :
You have 10 seconds to enter the NEXT
character. If you DO NOT PRESS the
next character within this time period the LED
on the keypad will flash repeatedly. You you must start the sequence again from
the beginning if this happens.
With the ignition OFF and the security system disarmed, type into the keypad the following:
1. Where 1234 represents the 4-digit PIN
code and 2 represents the total
number of radio transmitters to be recognised by the
security system (MAX 4).
2. To confirm correct input of you PIN code the siren will bleep after
entering the last digit. The numeric 91
is the access code or command, which tells the alarm unit to accept the new
transmitters.
3. Then PRESS the button on the first radio transmitter, the siren will BEEP, now PRESS the button on the second radio transmitter, the siren will BEEP again, continue with 3RD and 4TH radio transmitters (if applicable).
4. After PRESSING your final radio transmitter, wait 10 seconds. Finally TEST
that all your radio transmitters arm and disarm the security system.
EXAMPLE
So for example if the PIN code is 1234 and you
wish to program in 2 radio transmitters
you would type in:
Then PRESS
the remote keys at the appropriate time.
** 1234 Your
PIN code (the alarm will bleep).
* 91 Notifies
the alarm that you want to program the radio transmitters.
* 2 The
number of radio transmitters that you want to program in.
# Confirms
you want to program radio transmitters.