2004 > 2010
1. battery 1616
NOTE : Make sure the drivers door is OPEN and UNLOCKED and the key is out of the ignition.
1. Insert and remove the key from the ignition key cylinder twice within 5
seconds.
2. Close and open the drivers door twice within 40 seconds.
3. Insert the key into the ignition key cylinder and remove it.
4. Close and open the drivers door twice within 40 seconds again.
5. Insert the key into the ignition key cylinder.
6. Close the door.
7. Turn the ignition switch from LOCK
to ON and back to LOCK at about 1 second intervals
to select the desired mode.
NOTE : 1 time for ADD.
NOTE : 2 times for REWRITE.
NOTE : 3 times for CONFIRMATION.
NOTE : 5 times for PROHIBITION.
8. Remove the key from the ignition key cylinder.
9. To confirm your selection of all mode except CONFIRMATION mode, the power locks
will now cycle LOCK to UNLOCK a number of times corresponding
to your key cycles
in step 7.
NOTE : If CONFIRMATION mode has been selected, the power door locks will now
cycle
(in 2 seconds intervals) a number of times
corresponding to the number of transmitters currently
registered.
NOTE : Opening the door will
complete the procedure.
NOTE : If PROHIBITION mode has been selected, opening the door will complete
the procedure.
10. For ADD or REWRITE modes, within 20 seconds of Door Lock confirmation.
(a) Press the transmitter LOCK switch for more than 1 second and release.
(b) Within 3 seconds of step (a),
press the transmitter LOCK switch
for more than 1 second and
release.
(c) If the transmitter has been
successfully programmed, the power locks will cycle LOCK to UNLOCK.
once at this time. If there are problems with the procedure used up to this
point, the locks
will cycle twice, in which case you must go back and repeat the above steps
(a) and (b).
(d) If multiple transmitters are to
be programmed, repeat the above steps (a) to (c).
11.
Open the drivers door to complete the procedure.