OMRON RKE SYSTEM

NOTE : Receiver module location :

Expo LRV = Behind rear quarter panel at C pillar, above rear wheel well driver side

Expo = Behind rear quarter panel at C pillar, above rear wheel well passenger side

Montero = Behind rear quarter panel, forward of passenger side rear light cluster.

Diamante = Under rear shelf trim.

Galant = Under rear shelf trim.

3000GT = Behind rear quarter trim panel on driver side, near left speaker.

1.    With ignition OFF connect pins 1 and 4 of the OBD port together using a suitable jumper cable.

2.    Close all doors, trunk/boot and bonnet/hood.

NOTE : OBD socket locations can be found here www.wikiobd.co.uk

3.    Turn ignition to ACC position and then back to OFF.

4.    The doors should LOCK and UNLOCK to indicate programming mode.

5.    Press any button on the first remote transmitter slowly 3 times within 10 seconds.

6.    The doors should LOCK and UNLOCK to confirm remote transmitter is programmed.

7.    Repeat step 5 for all remote transmitters to be programmed.

8.    Disconnect jumper from OBD and remove ignition key.

9.    Test all remote transmitters for operation.