2005 > 2008
PROGRAMMING
NOTE : This procedure is complicated and needs to
be performed quickly. Please read through before you start to ensure it is
fully understood.
NOTE : Maximum 4 remote transmitters can be programmed.
NOTE : The next 5 steps need to be performed all within 45 seconds.
1.
Sit
in the drivers seat and ensure all the doors, trunk/boot and hood/bonnet are closed.
2.
OPEN and CLOSE
the drivers door 1
time.
3.
Within
45 seconds OPEN and CLOSE the drivers door.
4.
Switch
ignition from LOCK to ON 10
times within 15 seconds.
5.
A
sounder will sound once, and a buzzer will continue to sound and the interior
light will flash.
6.
Within
45 seconds OPEN and CLOSE the drivers door once, a sounder will sound for 30 seconds.
7.
PRESS
the power door LOCK button to LOCK for the number of times of the
first code digit number.
NOTE :
The sounder will stop once you start to enter the code. If the gap between
entering codes is more than 5 seconds an error will occur, start again at 3.
8.
PRESS the power door UNLOCK button within 5 seconds.
NOTE :
A sound will be heard at this point.
9.
Repeat
steps 7 and 8 for all 8 digits of
the remote transmitter code.
10. When complete press the power door lock
button to UNLOCK one time within 5
seconds of the last digit entered.
11. Then repeat the code entry again.
12. PRESS
the power door LOCK button to LOCK for the number of times of the
first code digit number.
13. When the code has been entered the second
time, a sounder will sound for 1
seconds.
14. To program another remote transmitter,
repeat the procedure starting at step 4.
15. Check all remote transmitters for
operation.
NOTE :
To delete any existing remote transmitters from the system, you must program
the new remote transmitters to fill the memory up, so if you have only one
remote transmitter then you must program it 4 times to fill in all the memory
slots. If you have 2 remote transmitters then you must
program each one twice.
SYNCHRONISATION
1.
Press
remote transmitter LOCK or UNLOCK button 6 times.
2.
Check
remote transmitter for operation.
ALARM DEACTIVATING
and ACTIVATING
1.
To
disarm the alarm, set VALET mode.
2.
Sit
in the drivers seat and shut all doors, trunk/boot and gate.
3.
SWITCH ignition ON.
4.
HOLD down the REAR UNLOCK side of the
drivers power door locking switch and OPEN
the drivers door within 1 second and
then wait 10 seconds before
releasing the switch.
5.
The
system will now be changed to VALET
mode and the trip meter display will show AL oF and
the horn will sound twice.