NOTE : All remote transmitters must be programmed at the same time.

NOTE  : A maximum of 4 remote transmitters can be programmed.

NOTE : All remote transmitters will be erased once programming mode has bee enabled.

1.    Remove the ignition key from the ignition lock.

2.    Ensure all doors are closed.

3.    Remove the MALL PGM fuse from the fuse box.

4.    Turn ignition to ACC position.

NOTE : The Body Control module will flash the seat belt indicator 1,2 or 3 times and Chime 1,2 or 3 times.

5.    Turn ignition to OFF position and then to ACC position within 1 second.

NOTE : The Body Control Module may begin to chime and flash the Diagnostic Trouble Codes (DTC) if any are stored.

6.    OPEN and CLOSE any door, a chime will sound when the vehicle enters programming mode.

7.    PRESS and HOLD the remote transmitters LOCK and UNLOCK buttons together for 14 seconds.

NOTE : After 7 seconds a CHIME will sound, ignore and wait for the second CHIME around 14 seconds.

8.    Repeat step 7 for all remote transmitters to be programmed.

9.     Remove ignition key.

10.  Replace the MALL PGM fuse.

11. Check all remote transmitters for operation.