2003 > 2009
1. battery 2032
1. Use a jumper wire and connect between terminals 11 and 12 of the 20 pin diagnostic connector, located in
the engine compartment close to the battery.
NOTE :
DO NOT user the 12 Pin OBD connector, otherwise you will
damage the vehicle systems.
2. Switch ignition ON.
3. Decided how many remote transmitters are to be programmed.
PROGRAMMING
1 REMOTE TRANSMITTER
4. PRESS and HOLD the LOCK button on the remote transmitter
to be programmed until the signal indicator lamps FLASH TWICE.
5. GO to STEP 8.
PROGRAMMING
2 REMOTE TRANSMITTERS
6. PRESS and HOLD the LOCK button on the first remote
transmitter for 1 second, until the
indicator lamps FLASH ONCE.
7. PRESS and HOLD the LOCK button on the second remote
transmitter for 1 second, until the
indicator lamps FLASH ONCE.
8. Switch ignition OFF and REMOVE key.
9. Remove jumper wire.
10. Check all remote transmitters for correct operation.
NOTE :
Maximum 2 remote transmitters can be
programmed.