1.    OPEN the drivers door.

2.    Insert key into ignition.

3.    SWITCH the ignition to the ACC position and then to the LOCK position 3 times within 3 seconds.

NOTE : Go as fast as you can, or the system will NOT enter the programming mode.

4.    Within 10 seconds, CLOSE and OPEN the drivers door 2 times.

5.    SWITCH the ignition to the ACC position and then to the LOCK position 3 times within 3 seconds.

6.    Within 10 seconds, CLOSE and OPEN the door.

7.    The door locks cycle once to confirm the system is in programming mode.

8.    Within 20 seconds, PRESS the LOCK button on the remote transmitter you are programming.

9.    Verify that the door locks cycle once.

10. Within 20 seconds, PRESS the UNLOCK button on the remote transmitter.

11. The door locks will cycle once to confirm that the system has accepted the transmitterÕs code.

12. Repeat steps 8 to 11 for each remote transmitter to be programmed.

13. Remove key from ignition.

14. CHECK all remote transmitters for correct operation.